https://youtu.be/mv0E9uLJSkw
Interesting video on drive belts from Ultimax (at about 22.30 point of video).

Picked up a 2015 SKI DOO BACKCOUNTRY 600. Has 1.75 paddle type track. SKI DOO ,Woodys ,etc. do not recommend to stud. However, woodys does make a 1.88 stud. which DEE'S Marine says they install in many Backcountrys they sell. (no warranty) but few if any issues. I know most off trail guys don't run ...

Anyone looking for complete shop manuals the are available to download at http://www.techsparkstudio.com . For some reason they don't have Polaris. Guess they figure they are to simple to need one. (I know, they "never break down" ) . pricing seems very reasonable.

I would think the El Tigre 600 would be a fine trail sled. If your talking on trail the 141 is unnecessary, except as "backup " for your 141. (you are talking artic cat.....). Although the 600 is a first year motor (again, arctic cat) did you consider the 7000 with the Excellent Yamaha 3 c...

Yamaha IS # 1 in quality
Ski-Doo IS # 1 in sales

Or, if you want to go with no. 1..................SKI-Doo !

Agree with Vitarious, you should remove the wire(s) going to starter. Although I'm not familiar with this sled most likely just a cable back to a solenoid. As far as removing battery , probably could do it, but I would check with dealer to be sure charging system will be o.k. good luck!

Womans CastleX snow pants size L Womans B C bibs size M Womans Choko jacket red/white size L Girls ZeroXposure jacket black/white/pink size16 Mens Yamaha/Reima jacket blue/black size M Mens Yamaha jacket blue/white/black size S Mens Vertical jacket blue/white /black size L Mens Cold Wave jacket purp...

In my experience , it seems best to run on the loose side of factory spec's. Track length/lug height ,#studs, clearance issues all factor in. The "ballooning" is usually only an issue at high speeds - 70-80, much more then a responsible rider would ever do..... :wink: ......btw, whats 5 co...

Yes, then you would want to stud the track before installing

Unless you're removing the track for some other reason, you can install studs on the sled fairly easily.
However, installing stubs on the floor, I'm not so sure about........

'

If you go to the http://www.woodystraction.com web site they recommend 162 1.450 studs as an "intermediate" set up. A graphic is also shown, 3 studs per bar in single or single /double backer patterns. Having done a few, I highly recommend the proper hole cutter drill (keep it sharp!) &...